Garage Door Floor Threshold Seal 2m

Garage Door Floor Seal Specifications

Garage Door Floor Seal Benefits

Garage door floor seals have risen in popularity in Australia since the recent mice plague. Commonly used in the UK (where they’re known as GaraDry), these seals are designed to keep out rain, leaves, and other debris. Auto Openers now manufactures an Australian-made garage door threshold seal that fixes directly to the concrete, helping create a stronger barrier against the elements and unwanted visitors.

This seal is strong enough to withstand trucks driving over it and helps prevent mice from entering. It’s especially useful if your driveway slopes toward the garage, causing rainwater to pool against the door and seep underneath. It also seals gaps from uneven floors, so there is no need to buy a tapered roller door!

The Auto Openers threshold seal is environmentally conscious, made from long-lasting rubber that can be recycled. Not only that, but using a floor seal will save you money by reducing energy costs from stopping heat escaping underneath and around your garage door.

Garage Door Floor Seal Installation

Step 1
Measure the overall width of the garage door opening (brick to brick) and add an extra 100mm overhang, so you can trim the seal to perfectly fit your door frame. Cut seal to length.

Step 2
Position the floor seal against the inside edge of the garage door frame, mark with a pencil where the floor seal needs to be trimmed to fit around the door frame at either end. Trim the seal using a Stanley knife and ensure a snug fit around door frame. The seal can be very tough to cut, clippers also work quite well.

Step 3
From inside the garage (with the garage door itself closed), push the floor seal firmly under the door so that the raised section of the seal is touching the bottom inside edge of the garage door. Once you are happy with the position, mark along the floor the entire length of the seal with a pencil, then open the door and carefully mark the floor along the outside edge of the seal.

Note: You can check a good fit by looking for light coming through between the threshold seal and garage door bottom seal with the door closed. There should be no light visible to ensure water-tight seal.

Step 4
Remove the floor seal apply a 4-5mm bead of sealant inside these lines in a zigzag formation. Once you have finished applying the sealant, immediately position the floor seal. We recommend the use of either Soudal Seal & Stick, or Sikaflex.

Step 5
Finally, starting at one end place the floor seal over the sealant on the floor and press firmly downwards, continuing until the entire floor seal and been stuck to the concrete. Carefully check fitment and make any necessary final adjustments before sealant cures. Excess sealant should be wiped clean immediately or trimmed once dry. Close your garage door on top of the seal.

We recommend installing your seal in the evening, so your floor sealant has time to cure overnight with the door pressing down on top. This can take 8 hours to properly cure, but is weather dependent.